To Assemble a Household Circuit Comprising Three Bulbs, Three (on/off) Switches, a Fuse and a Power Source

Aim
To assemble a household circuit comprising three bulbs, three (on/off) switches,a fuse and a power source.

Apparatus and material
Apparatus: No apparatus required in assembling a circuit.
Material: Three bulbs (6 V, 1W) each, fuse of 0.6 A, main switch a power supply (battery . eliminator), three (on/off) switches flexible connecting wire with red and black plastic covering,a fuse wire.
Supplementary: Main electric board with a two-pin socket and main switch.

Theory
Electricity supplied to us for domestic purposes is 220 V A.C. and 50 Hz. The household circuit, all appliances are connected in “parallel” with mains. The switches are connected in series with each appliances in live wire. 5 A switches are required for normal appliances like, bulbs, fluorescent tubes fans etc. 15 A sockets and switches are required for heavy load appliances ‘ like, refrigerator, air conditioner, geyser, hot plates etc. All appliances must have three wires called live, neutral and the earth. Total power consumption ‘P’ at a time
P = P1 + P2 + P3 +………..
where P1, P2, P3 are the powers drawn by appliances.
To protect the appliances from damage when unduly high currents are drawn fuse of  little higher rating, 10 to 20% higher than the current normally drawn by all appliances. For further safety, a suitable value MAINS FUSE like rating 32 A is connected in series with supply source.

Diagram

to-assemble-a-household-circuit-comprising-three-bulbs-three-onoff-switches-a-fuse-and-a-power-source-1

Procedure

  1. Connect the bulbs B1, B2 and B3 in series with switches S1, S2 and S3 respectively and connect each set of B-S in parallel with each other.
  2. Connect main supply to a step-down transformer (battery eliminator) to get required voltage from 0 to 10 V (0, 2, 4, 6, 8 and 10 V).
  3. Connect the mains fuse M.S. in series with the power supply (battery eliminator).
  4. Connect an A.C. ammeter in series with the B-S set.
  5. Connect one end of power supply to one end of B-S set.
  6. Check the circuit one again to ensure that household circuit is complete.
  7. Gradually increase the current to 0.75 A, the fuse must bum off at about 0.6 A.

Physics Lab ManualNCERT Solutions Class 12 Physics Sample Papers